Errata
Errors found so far in the 2005 reprinting of "An Introduction to Seismology, Earthquakes, and Earth Structure"
 Page 16, Table 1.24, last line: change “m/s” to “m sup 2 / s sup 2” (Thanks to Emile Okal for finding this.)
 Page 74, Figure 2.518, middle: change “x” to “x sub 0”
 Page 78, right side, line 5: change “(Eqn 2.5.8)” to “(Eqn 2.5.18)” (Thanks to Sum Mak for catching this.)
 Page 88, last line on left side: change “(22/sqrt3)” to “sqrt(22/sqrt3)” (Thanks to Thomas Blum and Emile Okal for catching this.)
 Page 91, first line: change “cos sup 2” to “2 cos sup 2” (Thanks to Douglas Toomey for catching this.)
 Page 91: In the third line after Equation (21), change "critically reflected" to "postcritically reflected" (Thanks to Yue Tian for finding this.).
 Page 91: In the line above Equation (24), change "Eqn 23" to "Eqn 22" (Thanks to Yue Tian for finding this.).
 Page 98: In the right side of Equation (27), change "v sub i" to "v sub j" (Thanks to Yue Tian for finding this.).
 Page 98: In the line below Equation (28), change "L sub ji" to "L sub ij".
 Page 105: Figure 2.95 has been corrected. The new version can be found HERE. (Thanks to Suzan van der Lee for finding this.)
 Page 117: In Problem #27b, change "depth of the slab" to "depth beneath the station to the top of the slab" (Thanks to Paul Richards for finding this.).
 Page 121, 8 lines above Eqn 4: change “an angle at or beyond the critical angle” to “an angle at the critical angle“.
 Page 125: Two lines below Equation (17), change "h sub u s the perpendicular distance to the interface below the receiver." to "h sub u = h sub d + x sin theta is the perpendicular distance to the interface below the receiver (Fig. 3.210)." (Thanks to Yue Tian for noticing this.).
 Page 162: In the second paragraph, change "Table 5.11" to "Table 3.51" (Thanks to Fabio Romanelli for finding this.).
 Page 166: In the secondtolast line of the second paragraph, change "3 pi / 4" to "3 pi / 2" (Thanks to Yue Tian for finding this.).
 Page 177: In the topright paragraph, line 10, change "crystal lattice" to "crystal lattices of an agglomeration of mineral grains" (Thanks to Paul Richards for finding this.).
 Page 185: Figure 3.613 has been corrected. The new version can be found HERE. (Thanks to Michael Ritzwoller for finding this.)
 Page 190: In Equation (3), change "B e sup i omega sub o t" to "B e sup i omega sub o t" (Thanks to Yue Tian for finding this.)
 Page 199: In the caption to Fig. 3.719, change "increases with depth" to "decreases with depth" (Thanks to Yue Tian for finding this.)
 Page 201, Eqn 17: change “g alpha tau” to “rho alpha tau” (Thanks to PoFei Chen for finding this.)
 Page 212, HW#4a: Change “distance y” to “distance y (along the surface)”
 Page 218: In the second paragraph in the right column (2nd to last line), change "Section 2.3.4" to "Section 2.3.5" (Thanks to Yue Tian for finding this.)
 Page 222: In the third line, change "M(t)" to "M dot (t)" [this is an "M" with a dot on top] (Thanks to Yue Tian for finding this.)
 Page 274: Two lines after Equation (1), change "greater than M" to "greater than or equal to M." (Thanks to Cliff Thurber for finding this.)
 Page 278, line below Eqn 9: change “e sup x” to “e sup x” (Thanks to Jerome Stein for finding this.)
 Page 325: In Figure 5.430, change the spelling of "Aleutions" to "Aleutians."
 Page 392: In the right hand side of Equation (1), change "]." "]dx."
 Page 392: In the right hand side of Equation (2), change "]." "]dz."
 Page 393: In Equations 6 and 7: change “p sub i (mu prime)” to “p sub i (x sub i )”, change “p(mu prime)” to “p(x sub i )”, change “P sub i (mu prime)” to “P sub i (x sub i )”, change “d/d mu prime” to “d/dx sub i”
 Page 426, Eqn 11: change “LAMBDA” to “LAMBDA sup 2” (Thanks to Malcolm Sambridge for finding this.)
 Page 426, line after Eqn 12: change “LAMBDA” to “LAMBDA sup 2” (Thanks to Malcolm Sambridge for finding this.)
 Page 426, Eqn 13: Each of the lambdas should be squared (Thanks to Malcolm Sambridge for finding this.)
 Page 426: add text after Eqn 13: “where the eigenvalues are written as squared because lambda sub i are the eigenvalues of G.” (Thanks to Malcolm Sambridge for finding this.)
 Page 427: change “LAMBDA” to “LAMBDA sup 2” and change “LAMBDA sup 1” to “LAMBDA sup 2” (Thanks to Malcolm Sambridge for finding this.)
 Page 427, EQN 16: change “LAMBA sup 1” to “LAMBDA sup 2” and square each of the diagonal terms (Thanks to Malcolm Sambridge for finding this.)
 Page 427, Eqn 19: change “LAMBDA” to “LAMBDA sup 2” (Thanks to Malcolm Sambridge for finding this.)
 Page 427: In the second line above Equation (20), change "decompose the matrix G" to "decompose the matrix GTG" [GTG is G superscript T G, as on left side of equation 11]
 Page 427: In Equation (20), change the left side from "G" to "GTG" [GTG is G superscript T G, as on left side of equation 11]
 Page 445: Figure A.31 has been corrected. The new version can be found HERE. (Thanks to Garrett Euler for finding this.)
 Page 445: Figure A.32 has been corrected. The new version can be found HERE. (Thanks to Garrett Euler for finding this.)
Return to main page.
